Jump to content


Scott81375

Member Since 03 Sep 2016
Offline Last Active Jan 09 2018 09:12 PM
-----

Posts I've Made

In Topic: Just getting started

27 November 2017 - 10:51 PM

Be careful. Its addicting!!!

In Topic: How to build up a spinning rear grip

20 May 2017 - 08:38 PM

I had glued my rings onto a 1/4 shaft and turned them down from there, and then ream out the grip. Glue it on the rod blank, and the cover the hole in the bottom with a decorative button that has a nipple in the middle of it. Fill the hole with epoxy and then put the button on with some masking tape to hold it on until dry. The nipple help hold the button on when the epoxy dries.

Haven't had one come off yet.

In Topic: First attempt at using craft foam

09 February 2017 - 12:19 PM

Again, that is a good looking grip.
 

 
Not too much and not to little, just the right amount.

Steve, that sounds like a line about the porridge from the Goldilocks story.

Lol. Thanks fellas. I appreciate the kind words

In Topic: New 240g tank build

07 February 2017 - 11:09 PM

Have you been watching the spin off ? (Better Call Saul). It's not on par with the drama/action of Breaking Bad but it's pretty decent.


I watched the first couple of them and was getting into it, but life got in the way. I'll binge watch on Netflix when work gets slow. Lol

In Topic: New 240g tank build

07 February 2017 - 08:44 PM

10-4 on that one. One of my favs for sure.