Jump to content


Photo

Flame Heat Treating - Another Approach


3 replies to this topic

#1 DHayashida

DHayashida
  • Members
  • 226 posts

Posted 16 November 2006 - 01:04 PM

1. First split the culm in half length-wise
user posted image


2. Break out as much of the internal dam as you can. You can use a chisel and remove all of it if you want
user posted image


3. Using a propane torch, start flaming from the middle and work towards the ends. Keep the flame moving, don't linger on one spot too long.
user posted image


4. If you see a lot of flame the section isn't done yet
user posted image


5. Continue to heat a section (keep the flame moving) until all you have is a glowing red spot and no flame
user posted image


6. When you get close to an end you will see the moisture and sap bubbling out of the end grain.
user posted image
user posted image


7. The outside of the culm remains unchanged, even after all that heat applied to the other side.
user posted image
user posted image


8. Wire brush off all of the burnt pith
user posted image
user posted image


9. The culm is ready to split. I do not do any more heat treating. No oven needed.

#2 Thanhvsn

Thanhvsn
  • Members
  • 3 posts

Posted 21 June 2007 - 09:52 PM

Dear DHayashida.

How about the heat treating after binding the strips?

**Edited by troutchaser to remove quote and repeat of pictures.

#3 bambooster

bambooster
  • Members
  • 39 posts

Posted 24 November 2007 - 08:42 AM

Hi..

How has this "flame heat treating" approach worked for you?? Any disasters? successes? TIA...

#4 Blackstone

Blackstone
  • Members
  • 17 posts

Posted 17 April 2008 - 06:55 AM

I tried this approach yesterday, and it seems like it's impossible to straighten.
It takes forever to heat the node again.Did I do something wrong?Any suggestions would be
appreciated.

Rick





Reply to this topic



  


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users