Jump to content
Posted 27 June 2016 - 08:58 PM
What is the best way to remove small particles and such from my wraps before I apply the finish epoxy?
I was thinking masking tape but just wanted to see if there are other methods?
Posted 27 June 2016 - 11:31 PM
Blue painters tape, the std can sometimes leave a residue
Ron WeberSouthwest Custom Rodswww.southwestcustomrods.comYour Lemke reel seat dealerhttp://www.southwest...l-seat-hardware
Authorized Snake Brand guide dealer
Posted 28 June 2016 - 05:25 AM
I use a gentle blast of air from canned air that is used for electronics. Note: gentle.
Marriage is like a deck of cards- in the beginning, all you need is two hearts and a diamond. In the end, you wish you had a club and a spade.
Posted 28 June 2016 - 08:52 AM
I have the painter's tape so i will give that a try.
THANKS fellas for the replies!
Posted 28 June 2016 - 12:52 PM
I singe it with an open flame, and then brush it off with a really soft bristle paint (artist's) brush. It doesn't take much to pop a wrap loose, though, so use a gentle touch.
Posted 28 June 2016 - 05:49 PM
What phg said. Had it happen tonight on two wraps on a rod in progress.
HTML mode is enabled.
0 members, 0 guests, 0 anonymous users
Community Forum Software by IP.Board 3.4.6