Jump to content


badboy6070bce

Member Since 25 May 2011
Offline Last Active Nov 24 2017 04:29 PM
-----

Posts I've Made

In Topic: Lathe accessories

23 November 2017 - 04:59 PM

Best not start WW3 again Tim.!!! Ha ha

In Topic: Lathe accessories

23 November 2017 - 04:58 PM

Hi Tim. Good to chat again. How are you mate??

Yep Tim is correct. Turning between centres is safe as pencil sharpening.

Remember theres not much pressure when sanding cork.

Be safe. Use the shortest thickest rod you can use. You can always ream out the cork if needed.

In Topic: Lathe accessories

22 November 2017 - 05:51 PM

Hi mate. I use a small 3 jaw chuck with a threaded rod thats covered with tape (for sanding) nut and washer at each end.

I pushed the threaded rod thru the headstock till no more than 1\2 inch was protuded and then I centre drilled the tail stock end with a little engineers stub drill to make sure it was correctly centetred.

Thats it SIMPLE!!

REGS
Chris

In Topic: Two strip quad queerie

22 November 2017 - 05:02 PM

Ok. Search for Tapani Salmi.
And on Power Fibers issue 28 for the ferrule.

In Topic: Complete bamboo rod making kit

29 March 2017 - 02:00 PM

COMPLETE BAMBOO ROD MAKING KIT (172598859612)  

 

Here it is!!

Thanks River Rat.., its called arthritis of the brain.

 

Really really sickened about this malady..,  but one door closes and another opens I suppose.

 

Take offers from you guys (reasonable) for all your help.

 

Regs